Synthesis of regularities of control of blocking properties of differential transmission mechanisms
https://doi.org/10.25206/2588-0373-2023-7-3-62-69
EDN: AOVECL
Abstract
The analysis of the operating conditions of four-wheel drive vehicles allows us to conclude that they are characterized by a continuously and significantly changing spread of the values of loads falling on the driving wheels, as well as the spread of resistance to movement and wheel adhesion to the bearing surface. In this regard, the degree of blocking of the inter-axle, inter-vehicle and inter-wheel connections should automatically change depending on the driving conditions, providing the car with the maximum reserve of traction forces with the minimum possible rolling resistance.
About the Authors
A. V. Popov
The State Scientific Center of the Russian Federation FSUE «NAMI»
Russian Federation
Russian Federation
Popov Andrey Vyacheslavovich, Graduate Student
Moscow, Avtomotornaya str., 2, 125438
S. V. Ushnurtsev
Omsk Tank-Automotive Engineering Institute
Russian Federation
Russian Federation
Ushnurtsev Stanislav Vladimirovich, Candidate of Technical Sciences, Associate Professor of Evacuation and Driving Department
AuthorID (RSCI): 697645
Omsk, Cheryomushki village, 14 Military town, 644098
A. V. Keller
Center for Sociological Research; Moscow Polytechnic University
Russian Federation
Russian Federation
Keller Andrey Vladimirovich, Doctor of Technical Sciences, Professor, Director; Scientific Director of an Advanced Engineering School
AuthorID (RSCI): 341094
Moscow, Tverskoy Boulevard str., 13, bld. 1, 123104
Moscow, Bolshaya Semenovskaya str., 38, 107023
References
1. Keller A. V. Printsipy i metody raspredeleniya moshchnosti mezhdu vedushchimi kolesami avtomobil’nykh bazovykh shassi [Principles and methods of power distribution between driving wheels of automobile base chassis]. Chelyabinsk, 2009. 218 p. ISBN 978-5-9772-0149-0. (In Russ.).
2. Murog I. A. Nauchnyye metody sovershenstvovaniya transmissii i rulevogo upravleniya pri modernizatsii avtomobiley mnogotselevogo naznacheniya [Scientific methods of improving transmission and steering in the modernization of multi-purpose vehicles]. Chelyabinsk, 2013. 32 p. (In Russ.).
3. Sirazetdinov T. K. Metody resheniya mnogokriterial’nykh zadach sinteza tekhnicheskikh sistem [Methods for solving multicriteria problems of synthesis of technical systems]. Moscow, 1988. 158 p. ISBN 5-217-00105-4. (In Russ.).
4. Lefarov A. Kh., Vysotskiy M. S., Vantsevich V. V. [et al.]. Energonagruzhennost’ i nadezhnost’ differentsial’nykh mekhanizmov transportno-tyagovykh mashin [Energy load and reliability of differential mechanisms of transport and traction machines]. Minsk, 1991. 239 p. ISBN 5-343-00828-3. (In Russ.).
5. Andreev A. F., Vantsevich V. V., Lefarov A. H. Differencialy kolesnyh mashin [Differentials of wheeled machines]. Moscow, 1987. 174 p. (In Russ.).
6. Petrushov V. A., Moskovkin V. V., Evgrafov A. N. Moshchnostnoy balans avtomobilya [Vehicle power balance]. Moscow, 1984. 159 p. (In Russ.).
7. Chistov M. P. Issledovaniye soprotivleniya kacheniyu pri dvizhenii polnoprivodnogo avtomobilya po deformiruyemomu gruntu [Investigation of rolling resistance when driving a four-wheel drive car on deformable ground]. Moscow, 1971. 16 p. (In Russ.).
8. Shuhman S. B. Obosnovaniye i razrabotka metoda povysheniya effektivnosti kolesnykh mashin za schet ratsional’nogo silovogo privoda [Substantiation and development of a method for increasing the efficiency of wheeled vehicles due to rational power drive]. Moscow, 2007. 48 p. (In Russ.).
9. Shuhman S. B. Kompleksnyye silovyye peredachi: Teoriya silovogo potoka i raschet peredayushchikh sistem [Theory of the power drive of the wheels of high-terrain vehicles]. Moscow, 2007. 333 p. ISBN 978-5-902792-15-4. (In Russ.).
10. Antonov A. S. Kompleksnye silovye peredachi: teoriya silovogo potoka i raschet peredayushchih system [Complex power transmissions: theory of power flow and calculation of transmission systems]. Leningrad, 1981. 496 p. (In Russ.).
11. Dygalo V., Keller A., Shcherbin A. Principles of application of virtual and physical simulation technology in production of digital twin of active vehicle safety systems // Transportation Research Procedia. Vol. 50. P. 121–129. DOI: 10.1016/j.trpro.2020.10.015. EDN: ZOPJNA. (In Engl.).
12. Tarasik V. P. Modelirovaniye ekstrennogo tormozheniya avtomobilya na opornoy poverkhnosti tipa «mikst» [Simulation of emergency vehicle braking on support surface of «mix» type] // Avtomobil’naya Promyshlennost’. Automotive Industry. 2022. No 1 (74). P. 64–75. EDN: YTFIPI. (In Russ.).
13. Keller A., Aliukov S. Effectiveness of Methods of Power Distribution in Transmissions of All-Wheel-Drive Trucks // SAE 2015 Commercial Vehicle Engineering Congress. 2015. DOI: 10.4271/2015-01-2732. EDN: WPDDSX. (In Engl.).
14. Keller A., Aliukov S., Anchukov V. [et al.]. Investigations of Power Distribution in Transmissions of Heavy Trucks // SAE 2015 Commercial Vehicle Engineering Congress. 2016. DOI: 10.4271/2016-01-1100. (In Engl.).
Review
For citations:
Popov A.V., Ushnurtsev S.V., Keller A.V. Synthesis of regularities of control of blocking properties of differential transmission mechanisms. Omsk Scientific Bulletin. Series Aviation-Rocket and Power Engineering. 2023;7(3):62-69. (In Russ.) https://doi.org/10.25206/2588-0373-2023-7-3-62-69. EDN: AOVECL
Views:
20
JATS XML
Email this article 