Reducing gas pressure pulsations in the suction line of a piston compressor when using throttle washers
https://doi.org/10.25206/2588-0373-2024-8-2-22-29
EDN: OUNXDZ
Abstract
This article discusses the problem of combating pressure fluctuations in the suction line of piston compressors. As you know, incorrect calculation of communications can lead to accidents of compressor equipment. Therefore, special attention must be paid to the layout of pipelines and equipment, while avoiding resonance phenomena. One way to combat pressure pulsations in the suction line is to install diaphragms. This method is the cheapest and easiest to implement, especially for compressors already in operation.
The experimental studies carried out confirmed the known data that the area of the diaphragm opening should be four times smaller than the diameter of the pipeline. At the same time, a threefold reduction in the amplitude of pressure fluctuations is achieved. Installation of a diaphragm design with parameters close to the recommended ones is possible anywhere in the suction line, since the change in amplitude at different pressure from the suction valves does not exceed 5...7 %. When installing a diaphragm with dimensions different from those recommended, it is necessary to install it closer to the suction valve.
About the Authors
S. S. BusarovRussian Federation
Busarov Sergey Sergeevich - Candidate of Technical Sciences, Associate Professor, Associate Professor of Refrigeration and Compressor Equipment and Technology Department. AuthorID (RSCI): 610336. AuthorID (SCOPUS): 51560987400.
Omsk, Mira Ave., 11, 644050
A. A. Kapelyukhovskaya
Russian Federation
Kapelyukhovskaya Alexandra Aleksandrovna - Senior Lecturer of Refrigeration and Compressor Equipment and Technology Department, OmSTU, SPIN-code: 2410-8153. AuthorID (RSCI): 684484.
Omsk, Mira Ave., 11, 644050
V. V. Voronin
Russian Federation
Voronin Viktor Vyacheslavovich - Undergraduate, gr. TMO-222 of Petrochemical Institute, OmSTU.
Omsk, Mira Ave., 11, 644050
K. A. Bakulin
Russian Federation
Bakulin Konstantin Aleksandrovich - Student, gr. TMO-192 of Petrochemical Institute, OmSTU.
Omsk, Mira Ave., 11, 644050
N. G. Sinitsin
Russian Federation
Sinitsin Nikita Glebovich - Student, gr. TMO-182 of Petrochemical Institute, OmSTU.
Omsk, Mira Ave., 11, 644050
References
1. Busarov S. S., Nedovenchanyi A. V., Sinitsin N. G. [et al.]. Experimental estimation of gas pressure pulsations in communications of high-speed reciprocating compressor units // AIP Conference Proceedings. Oil and Gas Engineering (OGE-2022). 2023. Vol. 2784. P. 030033-1–030033-5. DOI: 10.1063/5.0141786. (In Engl.).
2. Busarov S. S., Nedovenchanyy A. V., Bakulin K. A., Sinitsin N. G., Panyutich A. A. Eksperimental’naya otsenka vliyaniya chastoty vrashcheniya kolenchatogo vala na amplitudu pul’satsiy davleniya v gazovykh kommunikatsiyakh maloraskhodnykh porshnevykh kompressorov [Experimental evaluation of the influence of crankshaft rotation frequency on the amplitude of pressure pulsations in gas communications of low-flow reciprocating compressors] // Omskiy nauchnyy vestnik. Ser. Aviatsionno-raketnoye i energeticheskoye mashinostroyeniye. Omsk Scientific Bulletin. Series Aviation-Rocket and Power Engineering. 2022. Vol. 6, no. 2. P. 21–26. DOI: 10.25206/25880373-2022-6-2-21-26. EDN: ZRYBCJ. (In Russ.).
3. Voronkov S. S. Matematicheskaya model’ rabochego protsessa vysokooborotnogo dvukhstupenchatogo porshnevogo kompressora s uchetom nestatsionarnykh yavleniy v kommunikatsiyakh [Mathematical model of the working process of a high-speed two-stage piston compressor, taking into account non-stationary phenomena in communications]. Leningrad, 1982. 16 p. (In Russ.).
4. Perevozchikov M. M. Povysheniye effektivnosti ob”yemnogo odnostupenchatogo kompressora na osnove matematicheskoy modeli protsessov pri szhatii real’nogo gaza [Increasing the efficiency of a volumetric single-stage compressor based on a mathematical model of processes during compression of real gas]. Saint Petersburg, 1997. 16 p. (In Russ.).
5. Busarov S. S. Eksperimental’nyye issledovaniya pul’satsiy davleniya v gazovykh kommunikatsiyakh maloraskhodnykh porshnevykh tikhokhodnykh kompressorov [Experimental studies of pressure pulsations in gas communications of low-flow piston low-speed compressors] // Kompressornaya tekhnika i pnevmatika. Compressors and Pneumatics. 2022. No. 3. P. 24–27. EDN: DIUKAE. (In Russ.).
6. Frenkel’ M. I. Porshnevyye kompressory. Teoriya, konstruktsii i osnovy proyektirovaniya [Piston compressors. Theory, structures and design fundamentals]. 3rd ed. Leningrad, 1969. 744 p. (In Russ.).
7. Voronkov S. S., Prilutskiy I. K., Fotin B. S. K voprosu zadaniya granichnykh usloviy pri matematicheskom modelirovanii kolebaniy davleniya gaza v kommunikatsiyakh porshnevykh kompressorov [On the issue of setting boundary conditions for mathematical modeling of gas pressure fluctuations in the communications of piston compressors]. Moscow, 1982. 374 p. (In Russ.).
8. Kalekin V. V. Razrabotka i issledovaniye porshnevykh pnevmodvigatel’-kompressornykh agregatov s samodeystvuyushchimi klapanami [Development and research of piston pneumatic motor-compressor units with self-acting valves]. Omsk, 2005. 234 p. (In Russ.).
9. Chrustalev B. S., Zdalinsky V. B., Bulanov V. P. Mathematical Model of Reciprocating Compressor With One or Several Stages for the Real Gases // International Compressor Engineering Conference. 1996. P. 1108. URL: http://docs.lib. purdue.edu/icec/1108 (accessed: 03.12.2023). (In Engl.).
10. Prilutskiy I. K. Razrabotka, issledovaniye i sozdaniye porshnevykh kompressorov i detanderov dlya kriogennoy tekhniki [Development, research and creation of piston compressors and expanders for cryogenic technology]. Leningrad, 1991. 401 p. (In Russ.).
11. Plastinin P., Fedorenko S. Simulation of Transient Gas-Temperatures in Cylinders of Reciprocating Compressors Using Identification Techniques with a Mathematical Model // International Compressor Engineering Conference. 1978. P. 380. URL: http://docs.lib.purdue.edu/icec/295 (accessed: 03.12.2023). (In Engl.).
12. Perevozchikov M. M., Chrustalyov B. S. Theoretical and Experimental Researches of Unsteady Gas Flow in the Pipe of the Reciprocating Compressor // International Compressor Engineering Conference at Purdue, USA. 1994. Vol. 2. P. 515–520. URL: https://docs.lib.purdue.edu/cgi/viewcontent.cgi?article=2028&context=icec (accessed: 10.01.2024). (In Engl.).
13. Plastinin P. I. Porshnevyye kompressory. V 2 t. T. 1. Teoriya i raschet [Piston compressors. In 2 vols. Vol. 1. Theory and calculation]. Moscow, 2000. 456 p. (In Russ.).
14. Tesfamichael T., Ahsan M., Notarianni M. [et al.]. Gas sensing of ruthenium implanted tungsten oxide thin films // Thin Solid Films. 2014. Vol. 558. P. 416–422. DOI: 10.1016/j.tsf.2014.02.084. (In Engl.).
15. Fedyakov E. M. Izmereniye peremennykh davleniy [Measurement of variable pressures]. Moscow, 1982. 216 p. (In Russ.).
16. Kassandrova O. N., Lebedev V. V. Obrabotka rezul’tatov nablyudeniy [Processing of observation results]. Moscow, 1970. 104 p. (In Russ.).
17. Zakharenko S. E. Eksperimental’noye issledovaniye protechek gaza cherez shcheli [Experimental study of gas leaks through slits] // Trudy Leningradskogo politekhnicheskogo institute. Works of Leningrad Polytechnical Institute. 1953. No. 2. P. 161–170. (In Russ.).
18. Bland J. M., Altman D. Statistics notes: measurement error // BMJ. 1996. Vol. 313. P. 41–42. DOI: 10.1136/bmj.313.7059.744. (In Engl.).
19. Cochran W. G. Errors of Measurement in Statistics // Technometrics. 1968. Vol. 10, no. 4. P. 637–666. DOI: 10.2307/1267450. (In Engl.).
Review
For citations:
Busarov S.S., Kapelyukhovskaya A.A., Voronin V.V., Bakulin K.A., Sinitsin N.G. Reducing gas pressure pulsations in the suction line of a piston compressor when using throttle washers. Omsk Scientific Bulletin. Series Aviation-Rocket and Power Engineering. 2024;8(2):22-29. (In Russ.) https://doi.org/10.25206/2588-0373-2024-8-2-22-29. EDN: OUNXDZ
JATS XML

















